To make sure that you water softener in Arizona is functioning properly
you want to make sure that the salt levels in your water softener in Arizona
are correct. If you find that the salt levels are not going down by the
water softener is regenerating, there are a few ways that you can troubleshoot
First, there may be some kind of a mechanical problem with the water softener
in Arizona. Make sure that you don’t have a leaking valve. You can
also watch the regeneration process to make sure that it is working correctly.
This way you can tell if you need to call a qualified professional to
come and fix the system.
Second, salt may become solid just above the water level. Brine is water
that is saturated with salt and this salt can sometimes create a crusty
layer in the tank of your water softener in Arizona. This hard layer is
called a salt bridge and for your water softener in Arizona to function
correctly, you have to break up this layer and remove any large chunks
of salt. After that, the water softener should function correctly.
Third, occasionally salt crystals can cause a residue in the bottom of
the tank of your water softener in Arizona. If this occurs, it can block
the flow of water out of the tank and will make it so that regeneration
cannot occur. The best way to fix this problem is to empty out the water
softener in Arizona and clean it thoroughly, removing any residue in the
bottom of the tank.
Finally, the brine refill control could be clogged. If this happens it
makes it so that the brine cannot escape the tank. The water softener
in Arizona will register that the levels are correct and will not continue
the regeneration process.
If you have any questions about your water softener, feel free to call
a professional to fix the system.